Tuesday, July 8, 2014

New Enclosure for the bot

I finally finished my enclosure upgrade for my 3D printer. I chose the $15 enclosure pattern, not because it was cheap, but because is moved the side enclosure a little bit away from the X-axis cable so it wouldn't wear it's self against the side plexiglass, which is why I removed the side plexiglass and draped the bot with a towel for so long. Now that the towel's gone it looks a bit naked, but this enclosure is insuring it stays HOT inside that bot. We'll see how it fights off the Utah winter in 6 months.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.